Author Archives: hobby16

Keep the Gotway quiet

The buzzer on my Gotway 14″ MCM 2S 340Wh is very loud. It’s a piezzo device, powered by a 25% duty cycle 3.3 khz square signal. The signal’s amplitude is 65V (the battery voltage !), no wonder it’s loud, and super duper annoying for you and certainly much more for pedestrians.

Unfortunately, as it has been said at length on the forum, the buzzer can’t be cut off because the GW has no tactile warning like tilt-back or vibrations on any other wheels. Without the beeping, you can overspeed (which can happens even at… 6km/h when the battery is near flat) and then, the wheel WILL shut the power down and throw you off. Yeah, as unbelievably stupid as it seems, it’s totally true : the wheel shuts the power down when riding to… protect you, nice logic, no ?

To reduce the volume and to make a Gotway ride more bearable, I don’t do the 100 Kohm potiometer-series-connected mod, it’s has been out there since the Gotway exists as a testimony of the super duper annoying buzzer (Gotway, please, do something !!!).

Here is my way to tone down the buzzer : a screw.

gotway_buzzer

A2 Generic – BMS shunt

The A2 wheel is a generic X3 clone. The wheeler had a power cut because of a defective cell. After the shunt, no more power shutdown, even if the defective cell has not yet been replaced. All that happens then is a much less powerfull wheel because the defective cell (to be replaced) behaves like a short, leaving a battery pack with lower voltage, though a much more preferable and manageable situation than a sudden cutoff. More evidence of the criminally stupid idea of integrating a cutoff circuitry in an electric unicycle.

P.S. The wheel electronics is accessed from outside, which is a good point ! Mainboard is a X3 generic, with the same ridiculous heat sink which doesn’t sink anything and needs to be added a big aluminium plate.

Shunt by connecting B- to P- :

Continue reading